02/25/02 12.540 Lec 06 1
12.540 Principles of the Global
Positioning System
Lecture 04
Prof. Thomas Herring
02/25/02 12.540 Lec 06 2
GPS Observables
? Today’s class we start discussing the nature
of GPS observables and the methods used to
make range and phase measurements
? Start with idea of remotely measuring
distances
? Introduce range measurement systems and
concepts used in graphically representing
electromagnetic signals
? Any questions on homework?
02/25/02 12.540 Lec 06 3
Distance measurement
? What are some of the methods used to
measure distance?
? We have talked about:
– Direct measurement with a “ruler”
– Inferred distances by measuring angles in triangles
– Distance measurement using the speed of light
(light propagation time)
? GPS methods is related to measuring light
propagation time but not directly.
02/25/02 12.540 Lec 06 4
Direct light propagation time
? Distance can be measured directly by sending
a pulse and measuring how it takes to travel
between two points.
? Most common method is to reflect the signal
and the time between when the pulse was
transmitted and when the reflected signal
returns.
? System used in radar and satellite laser
ranging
02/25/02 12.540 Lec 06 5
Direct light propagation delay
? To measure a distance to 1 mm requires timing
accuracy of 3x10
-12
seconds (3 picoseconds)
? Timing accuracy needs to be maintained over the
“flight time”. For satellite at 1000km distance, this is 3
millisecond.
? Clock stability needed 3ps/3ms = 10
-9
? A clock with this longtime stability would gain or lose
0.03 seconds in a year (10
-9
*86400*365)
? (Clock short term and long term stabilities are usually
very different -- Characterized by Allan Variance)
02/25/02 12.540 Lec 06 6
Direct light propagation measurement
? The noise in measuring the time will be proportional
the duration of the pulse
? For mm-level measurements, need a pulse of the
duration equivalent of a few millimeters.
? Pulse strength also enters (you need to be able to
detect the return pulse).
? In general, direct time measurement needs expensive
equipment.
? A laser system capable of mm-level ranging to
satellites costs ~$1M
02/25/02 12.540 Lec 06 7
Reflecting the signal back
? With optical (laser) systems you want to reflect
signal back: a plain mirror won’t do this unless
perfectly normal to ray.
? Use a “corner cube” reflector. In 2-D shown
on next page
? For satellites, need to “spoil” the cube (i.e.,
corner not exactly 90 degrees because station
not where it was when signal transmitted)
02/25/02 12.540 Lec 06 8
Corner cube reflector
Corner Cube Reflector
Incoming and outgoing
rays are parallel
i
i
90-i
90-i
The return angle
is twice the
corner angle
For 90 degree
corner, return is
180 degrees.
02/25/02 12.540 Lec 06 9
Alternative way to measure distance
? Instead of generating a short pulse and
measuring round trip propagation time (also
requires return pulse be detected), you can
measure phase difference between outgoing
and incoming continuous wave
? Schematic shown on next page
? Basic method used by interferometer
02/25/02 12.540 Lec 06 10
Difference measurement (stays constant with time and
depends on distance)
-1.00
-0.50
0.00
0.50
1.00
0.0 0.4 0.8 1.2 1.6 2.0 2.4 2.8
Outgoing
Incoming
Outgoing +?t
Incoming +?t
Signal voltage
Distance
02/25/02 12.540 Lec 06 11
Higher frequency. Phase difference still says something
about distance but how to know number of cycles?
-1.00
-0.50
0.00
0.50
1.00
0.0 0.4 0.8 1.2 1.6 2.0 2.4 2.8
Outgoing
Incoming
Signal voltage
Distance
Reflection
02/25/02 12.540 Lec 06 12
Mathematics behind this
? In an isotropic medium a propagating electromagnetic
wave can be written as:
? Where E is the vector electric field, t is time, x is
position and k is wave-vector (unit vector in direction
of propagation divided by wavelength λ = velocity of
light/frequency
ω is frequency in radians/second, f is frequency in
cycles/second.
r
E (t,x)= E
0
e
?i(ωt?2πk.x)
= E
0
e
?i2π( ft?k.x)
02/25/02 12.540 Lec 06 13
Basic mathematics
? When an antenna is placed in the electric field
(antenna in this case can be as simple as a piece of
wire), the E-field induces a voltage difference between
parts of the antenna that can be measured and
amplified
? For static receiver and antenna, the voltage V is
? G is gain of antenna. The phase of signal is 2πx
0
.k
V(t)= GE
0
e
i2πk.x
0
e
?iωt
= GE
0
e
i2πk.x
0
e
?i2πft
02/25/02 12.540 Lec 06 14
Basic Mathematics
? The use of complex notation in EM theory is common.
The interpretation is that the real part of the complex
signal is what is measured
? To recover the phase, we multiple the returned signal
by the outgoing signal (beating the two signals
together)
? Take the outgoing signal to be V
o
cos(2πft)
? You also generate a π/2 lagged version V
o
sin(2πft)
? These are called quadrature channels and they are
multiplied by the returning signal
02/25/02 12.540 Lec 06 15
Basic Mathematics
? Using trigonometric identities:
? Using these relationships we can derive the
output obtained by multiplying be cos and sin
versions of the outgoing signal are
Re(e
?ia
cosb)=cosacosb =12cos(a+ b)+cos(a?b)
[ ]
Im(e
?ia
cosb)=sinacosb =12sin(a+ b)?sin(a?b)
[]
V(t)cos2πft =12GE
0
cos2πk.x
0
+12cos(2πk.x
0
+ 4πft)
V(t)sin2πft =12GE
0
sin2πk.x
0
+12sin(2πk.x
0
+ 4πft)
02/25/02 12.540 Lec 06 16
Basic mathematics
? Notice the 4πft term: this is twice the
frequency of the original signal and by
averaging the product over a period long
compared to 1/f, this will average to zero
? The remaining terms are the cosine and sine
of the phase
? This is an example of the “modulation
theorem” of Fourier transforms
02/25/02 12.540 Lec 06 17
Phasor Diagrams
? These cosine and sine output are often
represented in EM theory by phasor diagrams
? In this case it would look like:
Cosine channel
Sine channel
Rotating component that
will average to zero
Phase of averaged signal
02/25/02 12.540 Lec 06 18
Phase measurement of distance
? Phase difference between outgoing and incoming
reflected tells something about distance
? If distance is less than 1 wavelength then unique
answer
? But if more than 1 wavelength, then we need to
number of integer cycles (return later to this for GPS).
? For surveying instruments that make this type of
measurement, make phase difference measurements
at multiple frequencies. (Often done with modulation
on optical carrier signal).
02/25/02 12.540 Lec 06 19
Resolving ambiguities
? The range accuracy will be low for long-
wavelength modulation: Rule of thumb: Phase
can be measured to about 1% of wavelength
? For EDM: Use multiple wavelengths each
shorter using longer wavelength to resolve
integer cycles (example next slide)
? Using this method EDM can measure 10’s of
km with millimeter precision
02/25/02 12.540 Lec 06 20
Ambiguity example
? A typical example would be: Measure distances to 10
km using wavelengths of 20 km, 1 km, 200 m, 10 m,
0.5 m
? True distance 11 785.351 m
Wavelength Cycles Resolved Distance
20 km 0.59 0.59 11800
1 km 0.79 11.79 11790
200 m 0.93 58.93 11786
10 m 0.54 1178.54 11785.4
0.5m 0.70 23570.70 11785.350
02/25/02 12.540 Lec 06 21
EDM basics and GPS
? For optical systems where reflection is from a mirror,
this method works well
? For microwave, a simple reflector is difficult (radar).
Most systems are active with the “reflector” receiving
the signal and re-transmitting it (transceiver)
? Satellite needs to know about ground systems
? Some systems work this way (e.g., DORIS) but it
limits the number of ground stations
? GPS uses another method: One-way pseudorange
measurement with bi-phase modulation (explained
later)
02/25/02 12.540 Lec 06 22
GPS Methods
? Basic problem with conventional methods:
? Pulsed systems:
– “Idle” time in transmission (not transmitting during
gaps between pulses called “duty cycle”
– Pulses need to be spaced enough to avoid
ambiguity in which pulse is being received (There
are ways around this)
? Phase modulation systems:
– Active interaction between ground and satellite that
limits number of users
02/25/02 12.540 Lec 06 23
GPS Scheme
? GPS is like a pulsed ranging system except to avoid
“dead time” it effectively transmits negative pulses
? To minimize range ambiguities it transmits positive
and negative pulse in a known but pseudorandom
sequence.
? How do you transmit as negative pulse?
? Change the phase of the outgoing signal by π thus
reversing its sign -- Called bi-phase modulation
? The rate at which the sign is changed is called the
“Chip rate”
02/25/02 12.540 Lec 06 24
GPS scheme
? To see how this works, use phasor diagrams
? Assume we multiply the incoming signal by a
frequency that:
– exactly matches the GPS frequency;
– the sign changes occur at intervals long compared
to the GPS carrier frequency
– we average the high-frequency component
– Phase difference between GPS and receiver is not
changing
? Schematic of phasor diagrams shown next
02/25/02 12.540 Lec 06 25
Phasor diagrams for GPS tracking
Cos
Sin
Phase of averaged signal
Cos
Sin
Phase of averaged signal
Normal Phase
Transmission phase reversed
Notice if the two phasors are added, then averaged signal is zero
02/25/02 12.540 Lec 06 26
GPS tracking
? With the sign reversals in the GPS signal, if simple
tracking is used, then the signal averages to zero and
satellite can not be detected
? Signal strength of GPS transmission is set such that
with omni-directional antenna, signal is less than
typical radio frequency noise in band – spread
spectrum transmission
? Times of phase reversals must be known to track with
omni-directional antenna
? Pattern of reversals is pseudorandom and each
satellite has is own code.
02/25/02 12.540 Lec 06 27
GPS PRN
? The code is generated from a number
between 1-37 (only values 1-31 are used on
satellites, remainder are used for ground
applications)
? This is the pseudo-random-number (PRN) for
each satellite
? The 37 codes used are “orthogonal” over the
chip rate interval of the code, i.e., when two
codes are multiplied together you get zero.
02/25/02 12.540 Lec 06 28
GPS Codes
? The coding scheme is such that you can write
multiple codes on the same carrier and track
the signal even if one of the codes is not
known
? The overall sign of the code can be changed
to allow data to transmitted on the signal as
well
? In the next class we look at these details
02/25/02 12.540 Lec 06 29
Summary of Lecture 6
? Examine the methods used to measure range
with propagating EM waves
? Pulsed systems and phase systems
? GPS is a merger of the two methods
? Modulation theorem and phasor diagrams
allow graphical interpretation of the results.